TOP221-7好像都是700V的

資料中有段時這么寫的:
Cycle-By-Cycle Current Limit
The cycle by cycle peak drain current limit circuit uses the
output MOSFET ON-resistance as a sense resistor. A current
limit comparator compares the output MOSFET ON-state drainsource
voltage, VDS(ON) with a threshold voltage. High drain
current causes VDS(ON) to exceed the threshold voltage and turns
the output MOSFET off until the start of the next clock cycle.
The current limit comparator threshold voltage is temperature
compensated to minimize variation of the effective peak current
limit due to temperature related changes in output MOSFET
RDS(ON).

我說的VLIMIT就是VDS(ON)的一個比較門限,導通時VDS(ON)應該不會太大,所以這個值也應該不會太大才對,不過資料中沒有標明這個值啊

你要知道這個干什么,通態漏源電壓一般取10V

屬于IC內部參數

如果是您說的這個值得話請看看這個問題
http://bbs.dianyuan.com/topic/242052

我測出的波形中導通時電壓很高,可是看上去沒有受到這個VLIMIT的限制,這個就不好解釋了啊,對此正在郁悶中,不知道為什么MOS管導通時VDS這么大?

請幫忙看看這個波形是不是正常?或者問題出在哪里呢?謝謝!!
http://bbs.dianyuan.com/topic/242052

你那圖 變壓器絕對有問題 否則TOP不會出現那樣的波形 TOP導通時DS電壓最多10V 與流過電流有關

后來我同學幫分析了下,也認為變壓器有問題的可能性最大,畢竟變壓器不是我自己設計的,找人設計并打樣的,太貴了,而且參數也不知道,所以決定不再調那個變壓器了,想自己設計各變壓器,正在學習中呢.謝謝回復!!